FREE SHIPPING OVER $19
0

OSEPP IR Detector Module for Arduino

Catalog №: 2760449
On Sale Online only
Regular price: $9.99
Sale price: $8.99
Sale price: $8.99
Sale price: $8.99
$8.99
In Stock
Quantity
Get it ! Order in the next and choose Two-Day shipping at checkout.

This obstacle avoidance module detects when objects are within the calibrated range.

  • 100% Arduino compatible.
  • Three pinouts: G (Ground), V (5V), S (Signal).
  • Detects objects in range via infrared sensors.


Pin Outs Overview
This device has 3 pins: Ground (G), VCC (V), and Signal (S). The signal wire line is digital, it will either be high or low. It will be high if the detected range is further than the calibrated distance, or low if the detected range is less than the calibrated distance. 

Calibration
This device has two potentiometers you can adjust to calibrate the device. One for frequency (F) and one for distance (D). Much like an IR Remote, the IR light is oscillated at a defined frequency and detected at that same frequency; this enables the sensor to work in noisy environments. You can adjust the frequency to avoid interference with other detectors or other IR sources. You can set the distance the sensor is triggered from by adjusting the Distance potentiometer. Notice the LED will light up when it is triggered. Turn this pot clockwise to increase the distance, turn it counter-clockwise to decrease the distance.

Using the Module with an Arduino
Power the device by connecting Ground to Ground, VCC to 5v. Connect signal to a digital pin. You’ll then need to set the digital pin to INPUT mode. Read the digital pin. The pin will read high if an object is in the detected distance.

Specifications
Catalog No. 2760449
Mfg. Part No. IRDET-01
UPC 667510001035

 

Technical Schematic (PDF)
Source Code (ZIP)
Technical Data Sheet (PDF)

⚠️ WARNING: CHOKING HAZARD: Small parts. Not for children under 3 yrs.
Equivalent Part Numbers: 2760449   |  276-0449  |  276-449