10 Ohm, 1/2W 5% Carbon Film Resistor (5-Pack)

Comments about RadioShack 10 Ohm, 1/2W 5% Carbon Film Resistor (5-Pack):

These resistors are not dependable. Installed sixteen of these in voltage sensitive circuits and three shorted out in the first week destroying other components. The current draw was well below a half watt. Also the voltage tolerance is greater than 5%. Go find better quality more dependable resistors for your circuits.

Comments about RadioShack 10 Ohm, 1/2W 5% Carbon Film Resistor (5-Pack):

I used one of these resistors to replace a blown F1 Resistor/Fuse In my dreamcast.
The first resistor blown after plugging in an old controller.
I desoldered it and solderded this one on and it works great.
I haven't tested it with an additional power taker or a VMU yet but It looks like it can hold its own. Recommended for Controller PCB Repair

Comments about RadioShack 10 Ohm, 1/2W 5% Carbon Film Resistor (5-Pack):

well i fixed the f1 resistor on my dreamcast with this and the port works the only con is you can only have a max of 5 (iffy 4 or less work best) vmus or 1 rumble pack( by itself no vmus at all or else when the pack rumbles the contoller resets) in at the same time i think it pulls the voltage to the controller too low. but it does fix the problem

Comments about RadioShack 10 Ohm, 1/2W 5% Carbon Film Resistor (5-Pack):

I replaced the F1 resistor on my dreamcast. It looks different than the one I replaced, but it works just fine.

Comments about RadioShack 10 Ohm, 1/2W 5% Carbon Film Resistor (5-Pack):

I used this to replace my F1 resistor on my Sega Dreamcast, and now my controller port works